drivers: remove redundant PCI ID tables
- remove PCI tables where system.conf suffices
- remove drivers' ability to mess up NIC order
- fix dp8390 PCI enumeration
- convert ti1225 to instance model
- add system.conf entry for ti1225
On MFS file systems, the stat(2) call now counts indirect blocks as
part of the st_blocks calculation, in addition to proper initial
rounding of the file size. The returned value is now a true upper
bound on the actual number of 512-byte blocks allocated to the file.
As before, it is not accurate for sparse files.
On the x86, saving FPU state has the side effect of resetting this
state. In some cases (fork, getcontext), this would cause the state
to be lost. This patch restores the FPU state right after saving it,
except when different state is loaded immediately after.
Kernel: pass FPU restore exception to user process
Previously, user processes could cause a kernel panic upon FPU state
restore, by passing bogus FPU state to the kernel (through e.g.
sigreturn). With this patch, the process is now sent a SIGFPE signal
instead.
Tomas Hruby [Mon, 20 Feb 2012 13:19:29 +0000 (13:19 +0000)]
VFS - no CANCEL for async non-blocking operations
- if an operation (R, W, IOCTL) is non blocking, a flag is set
and sent to the device.
- nothing changes for sync devices
- asyn devices should reply asap if an operation is non-blocking.
We must trust the devices, but we had to trust them anyway to
reply to CANCEL correctly
- we safe sending CANCEL commands to asyn devices. This greatly
simplifies the protocol. Asynchronous devices can always reply
when a reply is ready and do not need to deal with other
situations
- currently, none of our drivers use the flags since they drive
virtual devices which do not block
Antoine Leca [Fri, 24 Feb 2012 12:29:10 +0000 (13:29 +0100)]
Cosmetic boot fix.
The NetBSD boot loader loads automatically the kernel module appropriate
for the detected root file system; it is preset at "ffs". The MINIX3fs
support does not reset the underlying global variable, since there are
no use for this on MINIX. As a result, the boot loader searches for
/ffs.kmod, and issues two warnings about "module failure to open/load."
Thomas Veerman [Wed, 22 Feb 2012 13:54:35 +0000 (13:54 +0000)]
VFS: improve crashed FS resource cleanup
When VFS detects that an FS has crashed and tries to clean up
resources, it marks fairly late in the process that a vmnt is not
to be used again (to send requests to). This allows a thread to
become blocked on a vmnt after all blocked threads were stopped, but
before it finds out it shouldn't try to send to that vmnt.
Thomas Veerman [Tue, 21 Feb 2012 10:16:42 +0000 (10:16 +0000)]
VFS: fix last_dir not returning last directory
If the provided path was only a single component (i.e., without
slashes), then last_dir would return early and skip the symlink
detection (i.e., check whether the path ends in a symlink and resolve
that first before returning). This bug triggered an assert in open
which expects that an advance after an last_dir (with VMNT_WRITE lock)
does not yield another vmnt lock.
Thomas Veerman [Mon, 20 Feb 2012 09:10:58 +0000 (09:10 +0000)]
VFS: remove erroneous assert
The assert was meant as an additional check to the assert in link.c:198.
The reasoning behind the assert in link.c:198 is that once you've
obtained a write lock on a vmnt, you can't get an additional read lock
on the same vmnt. However, that does not always hold for the assert in
path.c:281 where the situation could be that you've obtained a read lock
and managed to get another read lock (this is possible). In other words,
the assert in path.c:281 is not the right place to check for that
situation.
Thomas Veerman [Fri, 17 Feb 2012 13:36:57 +0000 (13:36 +0000)]
VFS: various select fixes
- Fix locking bug when unable to send DEV_SELECT request. Upon failure
VFS tried to cancel the select operation, but this failed due to trying
to lock a filp that was already locked to send the request in the first
place. Do_select_request now handles locking of filps itself instead of
relying on the caller to do it. This fixes a crash when killing INET.
- Fix failure to revive a process after a non-blocking select operation
yielded no ready select operations when replying DEV_SEL_REPL1.
- Improve readability by using OK, SUSPEND, and standard error values as
results instead of having separate macros in select.
- Don't print not having a driver for a major device; after killing a driver
select will trigger this printf.
Ben Gras [Thu, 16 Feb 2012 01:48:46 +0000 (01:48 +0000)]
install library manpages
. harmonize bsd.lib.mk and bsd.man.mk with netbsd files
. throw out minix section 3 (library calls) manpages,
replaced by netbsd ones that are now installed
Ben Gras [Sat, 11 Feb 2012 18:31:25 +0000 (19:31 +0100)]
Full switch to clang/ELF. Drop ack. Simplify.
There is important information about booting non-ack images in
docs/UPDATING. ack/aout-format images can't be built any more, and
booting clang/ELF-format ones is a little different. Updating to the
new boot monitor is recommended.
Changes in this commit:
. drop boot monitor -> allowing dropping ack support
. facility to copy ELF boot files to /boot so that old boot monitor
can still boot fairly easily, see UPDATING
. no more ack-format libraries -> single-case libraries
. some cleanup of OBJECT_FMT, COMPILER_TYPE, etc cases
. drop several ack toolchain commands, but not all support
commands (e.g. aal is gone but acksize is not yet).
. a few libc files moved to netbsd libc dir
. new /bin/date as minix date used code in libc/
. test compile fix
. harmonize includes
. /usr/lib is no longer special: without ack, /usr/lib plays no
kind of special bootstrapping role any more and bootstrapping
is done exclusively through packages, so releases depend even
less on the state of the machine making them now.
. rename nbsd_lib* to lib*
. reduce mtree
Evgeniy Ivanov [Sun, 12 Feb 2012 15:11:47 +0000 (19:11 +0400)]
make panic() work for multiboot/elf case
. we cannot use the boot monitor to print the system diag buffer
. for serial, we do nothing, just reset, everything is already printed
. for not-serial, we print the current diag buffer using direct video
memory access from the kernel
Thomas Veerman [Mon, 13 Feb 2012 12:02:12 +0000 (12:02 +0000)]
libmthread: add guard pages to stacks
Add guard pages to the top of the stack to catch overflow errors.
Moreover, fix a bug where libmthread would keep using a stack that was
just deallocated; a detached thread would deallocate its own stack after
it was finished running).
Antoine Leca [Tue, 17 Jan 2012 15:08:40 +0000 (16:08 +0100)]
writeisofs: also boots plain binaries with -B
With -n -b file, a.out boot images can be used for CD booting;
with the new -n -B file option, plain binary (like bootxx_cd9660)
can be used instead.
Restore working the -h and -f options while there.
And add a new -F option for 2.8MB floppy image.
Antoine Leca [Fri, 3 Feb 2012 10:24:48 +0000 (11:24 +0100)]
writeisofs: improve compatibility
Register file timestamps
Remember the path tables in the primary descriptor
Put the size of the parent directory in the \1 entry, not own size
Allow the use of -b option without -a
Notes:
* Still missing the man page
* Filenames are still trimmed to 12 characters, because of
8.3 MS-DOS inherited compatibility (ISO9660 level 1);
also note that 7.4 or 9.2 filenames are accepted though
* Final . at end of filenames without extension is still missing
* VMS-compatible ;1 version suffix is still omitted
* Limit of 65,535 directories in path tables is not checked
Evgeniy Ivanov [Tue, 31 Jan 2012 11:48:14 +0000 (15:48 +0400)]
Allow human readable name for the root device.
Instead of using rootdev= or ramimagedev= in the boot monitor
which are changed to numbers and cannot be used with other
loaders, rootdevname= or ramimagename= are (MINIX-style)
device names always stored as strings.
Evgeniy Ivanov [Mon, 30 Jan 2012 12:27:23 +0000 (16:27 +0400)]
Rotate kernels/images/modules.
Kernels and system services are stored in a single directory in the
/boot/minix/ and rotated like /boot/images. /boot/minix_latest slink
is created automatically.
System serives are prefixed by "modNN_" to allow to easily load them
using "mod*" pattern.