ide_pci_controller_t *ide_ctrl = ide_pci_controller + channel;
- int r = atomic_read(&(ide_ctrl->request_cnt));
- int i = atomic_read(&(ide_ctrl->irq_cnt));
- int c = atomic_read(&(ide_ctrl->consumed_cnt));
-
- printlxy(MPL_IDE0 + channel, MPO_IDE, "IDE%d req %u irq %u consumed %u", channel, r, i, c);
-}
-
-void ide_irq_handler(unsigned int irq, pt_regs_t *regs, void *devid) {
- // printk("ide irq %d handler pci status: 0x%02x\n", irq, ata_pci_bus_status());
- int channel = irq == ide_pci_controller[0].irq_line ? 0 : 1;
-
- const int drvid = (channel << 1); // 虚拟一个
- ide_pci_controller_t *ide_ctrl = ide_pci_controller + channel;
+ // 读相关status寄存器
+ const int drvid = (channel << 1); // 虚拟一个drvid
ide_ctrl->status = inb(REG_STATUS(drvid));
ide_ctrl->pci_status = inb(ide_ctrl->bus_status);
+ //
atomic_inc(&ide_ctrl->irq_cnt);
- ata_dma_stop(channel);
+ //
+ int r = atomic_read(&(ide_ctrl->request_cnt));
+ int i = atomic_read(&(ide_ctrl->irq_cnt));
+ int c = atomic_read(&(ide_ctrl->consumed_cnt));
+ printlxy(MPL_IDE0 + channel, MPO_IDE, "IDE%d req %u irq %u consumed %u", channel, r, i, c);
// 之前这里是用up()来唤醒磁盘任务
// 但在中断的底半处理,不应该切换任务,因为会引起irq里的reenter问题,导致不能再进底半处理,也无法切换任务
// 所以就移除了up()里的 schedule()
// 后来就改用完成量来通知磁盘任务,就不存在这个问题了
-
// complete会唤醒进程,但不会立即重新调度进程
complete(&ide_ctrl->intr_complete);
+}
+
+void ide_irq_handler(unsigned int irq, pt_regs_t *regs, void *devid) {
+ // printk("ide irq %d handler pci status: 0x%02x\n", irq, ata_pci_bus_status());
+ int channel = irq == ide_pci_controller[0].irq_line ? 0 : 1;
+
+ ata_dma_stop(channel);
- // 纯debug打印
add_irq_bh_handler(ide_irq_bh_handler, (void *)channel);
}